Advanced Construction And Carpentry Skills Volume 2 By Bonnici – Test Bank

Chapter 11 Testbank Key

1. To fit clothes on a coat hanger, a wardrobe should be at least:
   A.900 mm
   B. 450 mm
   C. 750 mm
   D. 600 mm

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 1.1

2. The most commonly used hinge on contemporary kitchen cupboards is the:
   A.piano hinge
   B. butt hinge
   C. concealed hinge
   D. cabinet hinge

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 2.2

3. It is not recommended that benchtops be glued down to the carcase because it:
   A.makes it hard to remove in case of damage
   B. can not be packed level during installation
   C. can not be removed if a drawer is stuck and cannot open
   D. needs to be able to move, expand and contract in relation to the carcase

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 4.2

4. To plane or cut a component so that one edge follows the shape or angle of the wall or floor is known as:
   A.fitting
   B. scribing
   C. shaping
   D. placing

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 3.3

5. Piano hinges are best used when a rigid hinged joint is essential.
   TRUE

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 2.2

6. When glueing large areas of laminate sheet to a benchtop it is good practice to lay the glued sheet down on lengths of dowel first and then remove the dowels once the sheet is aligned correctly.
   TRUE

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 4.2

7. A set-out rod should be used to mark out full-sized vertical and horizontal sections. It is not always necessary to show full depth on each rod.
   TRUE

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 2.3

8. KD, or ‘knock-down’, fittings have the disadvantage that once installed they cannot be disassembled.
   FALSE

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 4.1

9. Mechanical drawer runners with ball bearings should not be used on drawers that will be used by the elderly as they can be extremely difficult to pull open.
   FALSE

Competency: CPCCJN3004A Manufacture joinery components
Difficulty: Easy
Performance criteria: CPCCJN3004A 4.1

The special needs of a client may require you to change:

the way a door is hinged

the height of benchtops

the height of overhead cupboards

All the answer are correct.